Forrest MM10106 Miter Master 10-Inch 100 Tooth 5/8-Inch Arbor .105-Inch Kerf Wood Cutting Circular Saw Blade Review
Forrest MM10106 Miter Master 10-Inch 100 Tooth 5/8-Inch Arbor .105-Inch Kerf Wood Cutting Circular Saw Blade Feature
- No splinters cross-cutting oak, ply veneers and melamine
- Cuts in all directions- rip, cross-cut, miter, any depth.
- Cuts all sized grooves 1/4" through 29/32" increments. (Set of plastic adjusting shims also included)
- Super-hard carbide gives up to 300% longer life, especially good on plywoods and abrasive particle-boards.
Forrest's blades offer a superior cut that leaves a rip-cut saw edge that is as smooth as if it had been sanded, and a cross-cut edge that is almost mark-free. The blades run very quietly, and backside tearout in plywood is negligible. Each blade is virtually hand-made. The plate is hand-tensioned (up to 15 minutes per blade), superior C-4 carbide teeth are hand-brazed to the plate, and the blade is straightened and restraightened multiple times throughout the process. Think of a Forrest blade as a tool in your shop, not an accessory. Forrest stands behind it's blades by offering a sharpening service that bring blades back to the exact tolerances offered in a new blade. And this same exacting service is available for other manufacturer's blades as well, so they should come back better than new. Recommended for: thin, low pressure, two-sided laminates, plywood & fine cross cutting on all woods. Eliminates need for a small scoring saw blade on table saw work. The 40° points slice through thin bottom layers with no tears or chips. Reduced yearly sharpening costs - less machine downtime.No splinters cross-cutting oak, ply veneers and melamineCuts in all directions- rip, cross-cut, miter, any depth.Cuts all sized grooves 1/4' through 29/32' increments. (Set of plastic adjusting shims also included)Super-hard carbide gives up to 300% longer life, especially good on plywoods and abrasive particle-boards.
0 ความคิดเห็น:
แสดงความคิดเห็น